Re: Thanks, Mark!


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Willy-N [108.162.216.23] on Thursday, March 10, 2016 at 09:38:14 :

In Reply to: Re: Thanks, Mark! posted by Chewie [108.162.216.63] on Thursday, March 10, 2016 at 06:29:29 :

Just another thing. If the material is cold you can warm it up with a heat gun and make it bend easier. On the back I clamped a 2x4 to the material edge hanging over a table with a 2x4 clamped on the table holding the sheet. With about 12+ inches hanging in the air I warmed up the sheet even and watched it bend down and let it cool before putting it on the back to form the 2 curves needed to make it fit good. It does not need to get real hot to do this. Once you do one end turn the sheet around butt the curve up against a 2x4 clamped to the table to hold the curve while you do the other end the same way.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com