Re:Rear View Picture of the Canopy


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Willy-N [108.162.216.61] on Sunday, February 28, 2016 at 20:04:32 :

In Reply to: Re:Another Angle Pictures of the Canopy Tarp posted by Willy-N [108.162.216.61] on Sunday, February 28, 2016 at 19:53:42 :

I am making a rear rack for the bed. It is the same height as the front one. This will allow stuff to still be put on top when the canvas is on. Nice spot for a small boat? I will weld up the ends like the front one with flat bars and D-Rings on each end. On the bottom I will use 2-4" long 3/8" angle iron welded to the rack. Then they will be drilled in 3 places each and bolted into tapped holes in the bed steel. The steel under it is 2 layers of 3/16" to tap for the bolts. I will use a hydraulic jack to push the sides out the 1/4" I need to make the tailgate not fit so close. The angle iron goes on the inside edge and top of the sides and bolts both ways. This will also make the back much stronger giving it support across the back. Right now it is just sitting on the top of the bed I need to finish it first.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com