Posted by Willy-N [72.168.160.211] on Monday, December 07, 2015 at 20:52:13 :
In Reply to: Hydro Booster Mounted Pictures posted by Willy-N [72.168.160.211] on Monday, December 07, 2015 at 20:42:58 :
These are the two extra levers. They went on each side of the one coming down from the booster. The pivot pion will be at the end of these after I cut the angle end off and drill them for the pivot rod bolted to the bottom of the frame. The rod from the brake pedal will be hooked to a box steel extender for more strength and have a flat tap welded on the end to go between these flat bars and cross bolted. Now I can adjust the push on the new booster raising and lowering this tab a little. Since the flat bars are about the same length I should be able to match up the needed distance and still keep the same leverage pressure as if I went strait to the unit. The 3" needed push on the lever can be done with 1 Inch of push near the lower pivot point bolted to the frame once I figure this point out to drill the hole for the rod. Should be a solid set of linkage with nylon bushings and no play to deal with. Totally adjustable at the brake pedal for length and free play on the pedal.
Follow Ups: