Allowing for the double spline?

Posted by Chris Case [108.247.147.90] on Friday, November 20, 2015 at 17:18:46 :

In Reply to: WC1/2 pitman arm spline ID - same as WDX? posted by Don in NH [69.131.112.246] on Friday, November 20, 2015 at 16:14:46 :

There may be a double wide spline that will allow the arm to go on in only one place. It has to line up with a double gap on the shaft.

I've had to file it away to clock the arm appropriately on all the conversions I did.

Follow Ups:

• being lazy I elected to - muddy coast Bruce 18:58:41 11/20/2015
  • Exactly. - Chris Case 19:05:11 11/20/2015
    • Re: Unfortunately it doesn't even start - Don in NH 19:28:40 11/20/2015

Post a Followup