Posted by Willy-N [72.171.192.61] on Thursday, October 22, 2015 at 20:09:20 :
In Reply to: Re: Door Glass Question on Trim? posted by Brent [206.174.171.51] on Thursday, October 22, 2015 at 18:11:53 :
I just found out I can buy it local. I got my Seat Belts in completely. The smaller channels fit great inside the frame jam around the door. There is plenty of room to bolt them into it from the door side into the channel. You would have to rip out the whole jam to pull them out. Just need a small hole thru the head liner to bolt them on with. Bent a "L" Shaped Bracket and ran the Bed Spring Mount bolt thru it. Then I bolted the Reel and one end of the belt on it. The other short Cable buckle I bolted to the frame in the center under the seat so they will come thru the seat gap. Again to pull that one out you would have to rip out the seat mount 4 ft of 3/16" Angle Iron and my seat 2 1/4" angle iron frame that is bolted to it that holds the seat in. Later I may run a steel strap down to the floor and bolt thru it for more strength. I also got my Original Mirrors on and replaced all the door latch & Handle screws with stainless steel ones. That's enough for a days work.