Ordered my 12 Volt Dual Hydraulic Pump


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Willy-N [72.171.192.59] on Wednesday, September 23, 2015 at 01:22:58 :

Ordered it tonight as I need to plumb it into my Cylinder for my Dump Bed. It is a dual acting pump so it will pump up and pump down by circulating the fluid back and forth from the top and bottom of the 2 cylinder. I went for the 1,500 PSI one which will lift around 10 tons easy with my cylinders way more than it will ever have in the bed. I can adjust the PSI lower to protect the bed
from lifting more than it is designed to do. $330.00 with shipping best cost I could find on Ebay for the type I needed. Now I need to get a weather proof box for it to go in under the frame. Wish I hadn't gave away all the extra Hydraulic Hose & Fittings I had after putting a front end loader with tilt cylinders on my tractor. The control will go under the seat but long enough to get to the back of the bed and use it there also. Should work neat since this type was designed for Dump Bed Trailers. I could also set it up to switch over to operate a snow plow. I will have to wait to get my fittings and hose not sure what size the holes are. They make nice screw in ones and you just cut the hose to fit. I used this type on my tractor and have never had a leak for around 7 years and it goes up to 2,800 PSI.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com