Posted by Bob C. on Wednesday, August 22, 2001 at 6:44AM :
In Reply to: ENG # posted by George{ from alberta} on Wednesday, August 22, 2001 at 1:06AM :
Hi George
Sure sounds like an "Industrial" engine.
Be careful....measure the block to establish whether you have the 236/251/265..... than you will have to take out that 1/4 plug on cyl. 5 or 6 and measure the stroke.....and check against the spec. sheets for the stroke. It is very hard to tell them apart.
Bought a block marked IO and four digits... measured the required 25 inches and found out I had a 236...... came from an irrigation pump.... had just been rebuilt and something feel on the head and puncha hole through the water jacket..... but for the $25 bucks I paid I got my moneys worth....
In your neck of the woods you should be able to find some old Massey combines with 265 IND.
Good hunting.
Bob C. ( from Ontario)
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |