Got my Hitch on with the Bearing Mount. PICT

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Willy-N [72.171.192.117] on Thursday, August 13, 2015 at 22:58:03 :

Got all the bolt holes drilled, center support in for the hitch and Side Bed Bracket ready for 1 1/8" Cold Rolled Shaft across the back. The Bed is going to have a frame made out of 2" X 4" X 3/16" thick Box Steel on edge. This will set down inside the side brackets on a rubber plate. The hinge will be at one end and about 5 1/2' back will be the reinforced mount for the cylinder end to pin to. Low profile but still strong when the bed also bolts to the frame with cross members.

Follow Ups:

Re: Finish the Hitch and Skid Plate Drop. Pict - Willy-N 22:46:41 08/14/2015

Re:Diffrerent Angle View Picture - Willy-N 22:53:10 08/14/2015

Re: Got my Hitch on with the Bearing Mount. PICT - Marty 03:13:47 08/14/2015

Pintle....sorry! - Marty 03:15:07 08/14/2015
- Are you confusing --- - Chris Case 08:27:06 08/14/2015
  - Re: Are you confusing --- - clueless 12:03:56 08/14/2015

Re: Left out the Painting Part - Willy-N 23:22:53 08/13/2015

Re: Another View of the Bed Area - Willy-N 23:09:06 08/13/2015

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com