Posted by casebro on Wednesday, August 15, 2001 at 5:27PM :
In Reply to: Re: Whattya do? posted by Ed C. on Wednesday, August 15, 2001 at 5:18PM :
Caster wedges in front or back. But the down side of adjusting your caster in front is - now you've gotta angle trnsfer case for front driveshaft angle, then adjust rear axle via caster shims to suit transfer case and also motor mounts to suit angles of intermediate shaft- it's a never ending story when it comes to U-joint wear.
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |