Posted by Willy-N [72.171.192.120] on Monday, March 16, 2015 at 01:32:34 :
Here is one of the weld on the inside of the frame for the splice. I will take one of the other side. I just took it in the rain for you. On the other side is another section of frame that goes by the weld. The photo site has more pictures and descriptions. You can see the cross member looks to be original to the Power Wagon frame haft I think. There is no more splices in the frame. On the back end I think they removed the 6X6 bumper Cross Member and welded in the Power Wagons Cross Member a few inches forward on the frame ends. It was done OK and just needs touch up. My Cross member has the PTO Hole in the middle of it not sure if the 6X6 does. Lot of little things to clean up on the frame when I get the engine done. I would like to grind off any little things put on over the years under and on the frame. Once that is done I will sand blast it and paint it with Epoxy Primer first then several coats of Gloss Black. I will still need to deal with the axles at some point. The Pivot Point on the rear axles plate now shows after cleaning it good. I just need new bolts and to make 2 new round flat covers with 4 holes in it to fix that problem.
Follow Ups: