Posted by Fred Coldwell on Tuesday, July 24, 2001 at 3:17AM :
In Reply to: Belt Pulley System and rear PTO on a WM300 posted by Ed Kammerer on Monday, July 23, 2001 at 11:55PM :
Hi Ed:
The belt pulley system was made in-house by Chrysler, not by any outside vendor. It was designed specifically for the Power Wagon by factory engineers.
As Clint mentions, a later Ford belt pulley with a 1-3/8" female spline can be adopted. An article on this adopttion appeared perhaps 13 years ago in a back issue of Power Wagon Advertiser.
A schematic diagram of the belt pulley system appears in the old PW sales literature of which I sell photocopies. I'd recommend POWER ON THE FARM as the best of the lot on the belt pulley. Look in Joe's website under literature.
I don't know of any for sale. Good luck with your search.
Fred C.
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |