Posted by Larry [76.246.176.4] on Friday, September 12, 2014 at 02:30:25 :
In Reply to: 72-74 NP435 output W200 vs W300 posted by Larry [76.246.176.4] on Friday, September 12, 2014 at 02:07:08 :
Guess a fella can't edit their post?
Anyway, measured the W300's 727 output shaft at around 1.565 dia. Yoke attaching bolt around 3/4". Ok, the yoke is bolted on, not welded! Been away from this too long and not thinking right anyway.
I can't get to the output shaft of the divorced 435 in my 72 from the underside because of the tranny support. Will have to go through the floor board when I have time if need be, but I'm sure one of you are going to tell me it is smaller than the W300 stuff.
So, how hard will it be to find a W300 divorced 435? LOL
Follow Ups: