Posted by Paul H on Monday, July 16, 2001 at 11:26PM :
In Reply to: Re: NOT NECESSARILY posted by MoparNorm on Sunday, July 15, 2001 at 7:54PM :
Norm, both of my 318 polys are from '60 Dodge cars, pulled them myself. Both of them were installed in a '60 D100 w/factory Torqueflight, cast iron case.
I also have a cast bellhousing with casting numbers on the pass. side front of: 179959-2. Centered under that no. are the letters CWC and then smaller C189. Has pass. side slave cyl., 5 1/16" brg retainer hole and 45 degree angle mounting pads. I've had it for ages and can't remember what I pulled it out of. I have had it bolted on the 318 and an old 230 flathead six; two sets of bolt and dowel pin holes. Any clues? Thanks.
Paul H
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |