Re: lifting a front axle assembly

Posted by Fred Coldwell on Monday, July 16, 2001 at 10:31AM :

In Reply to: Re: diffs posted by Keith ( up north ) on Monday, July 16, 2001 at 9:55AM :

Depends on the surface. I use small 4 wheel carts to roll them around inside my garage. I get the axle assembly into my truck by raising it with a 2 ton chain hoist, backing the truck underneath, then lowering the axle assembly into the truck bed. When at an outdoor storage lot, I have used a hydraulic engine hoist to lift them off the ground then back the truck underneath. You might be able to move it the 100 years by rolling it on its drums at each end to get it near the truck.

Follow Ups:

Re: lifting a front axle assembly - Mike M. 12:39PM 07/16/2001

getting old and slow... - Fred Coldwell 1:54PM 07/16/2001

Re: lifting a front axle assembly: Fred C see above post NT - Mike M. 12:41PM 07/16/2001

Re: lifting a front axle assembly: Fred C see above post NT - keith ( up north ) 2:21PM 07/16/2001

Re: lifting a front axle assembly: Fred C see above post NT - David Sherman 0:15AM 07/17/2001

Thanks for the advice NTX - keith ( up north ) 4:29PM 07/16/2001

Post a Followup

Name:

E-Mail:

Subject:

Message:

Optional Link

URL:

Title:

Optional Image Link

URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com