Posted by Nick [99.100.212.49] on Sunday, March 02, 2014 at 20:26:49 :
In Reply to: Nick posted by Kaegi [98.247.164.246] on Sunday, March 02, 2014 at 19:10:31 :
Steve, pressed them in with a socket. Went in just fine, no problems.
Clark, the spindle nuts were tight, no play in the drums. And to be perfectly honest, I don't recall which direction I put them in. I knew less then than I do now, so I may not have put them in correctly. And there is nothing left of either one, they are shredded. Good thing I was changing the third member, there was so much debris in the pumpkin from both seals. Good thing I had free wheeling hubs on too, so all that debris just sank to the bottom, and didn't get circulated up into the bearings of the third members. Got it all cleaned out, with brake cleaner, no debris now.
Got the third ember installed, got the caliper brackets on and the axle shafts back in. Just waiting for the 1/2 inch hex head socket to come in to Sears, for installing the rotors on the hubs. I had to order it. So Im kinda at a stand still
Follow Ups: