Re: need a couple of mu2 parts.


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Keith in Washington [24.41.55.59] on Sunday, November 03, 2013 at 00:54:42 :

In Reply to: Re: need a couple of mu2 parts. posted by Keith in Washington [24.41.55.59] on Sunday, November 03, 2013 at 00:41:11 :

Paul. Look at the bolt pattern on the piece in his picture. It is a front support. The end closest to you in the picture is the drivers side which is cut at 90 degrees. The beveled cut end is hard to see in the picture is on the passenger side end. All the holes in his picture match the front support. The rear support has a single bolt hole at each end on the bottom then two holes on the vertical face at each end for mounting the winch. The front support has two hole on the vertical and bottom faces at each end which show in his picture. There are also two holes in the middle of the vertical face which are barely visable in his picture.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com