UPDATE 2....


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by CSCameron [174.26.83.2] on Wednesday, October 02, 2013 at 18:03:28 :

In Reply to: 6v or 12v Fuel Sender? posted by CSCameron [174.26.83.2] on Tuesday, October 01, 2013 at 13:20:44 :

Ok, I reinstalled the fuel gauge back in the truck, hooked up the power lead, ran a test lead from the sending post to the frame, applied power, and the needle pegged. Yay!

Then, I hooked up the sending unit from the tank, applied power, nothing. Leaving the sending unit hooked to the gauge, I ran a test lead from the sender directly to the frame and applied power again, pegged the needle! However, the tank is empty????

Not wanting to remove the sending unit from the tank, I tried inverting the tank to see if I could get a different reading, but it still pegs.

The sending unit is a brand new one from VPW. Suggestions?



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com