Help needed


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Jack McDevitt [216.246.159.243] on Wednesday, July 17, 2013 at 19:16:05 :

I recently purchased a rebuilt Dodge 251 cu. in. military engine. Unfortunately the engine had been sitting for a while, and we found the rings and bearings to be rusted beyond the point of being used. I have had not problem in finding the rings and rod bearings, HOWEVER the crank/block bearings are a different story. The bearings have MS stamped on them. The bearing dimples are on the opposite site of the civilian version. Finally the MS version bearings have 2 oil holes while the civilian versions only have 1. The bearings were made by Clevite. I would really appreciate and advise as to were I might be able to purchase the proper bearings. Thanks, Jack.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com