Posted by Clint Dixon on Tuesday, May 15, 2001 at 10:21PM :
In Reply to: Re: Parts books show... posted by George on Tuesday, May 15, 2001 at 9:42PM :
George,
Doors that are made to accept vent windows have the inner (towards driver) panel formed with indentations and holes that are used to bolt the front window track to. This special track is not used if you have full one piece windows. The door I have, that will not accept vent windows, does not have this special forming or the holes. These holes are slotted front to back. This provides adjustment of the track to place the window forward or rearward so as to clear the vent window correctly. There are 4 of these holes. Upper set and lower set. The holes in a set are about 2 inches apart (front to back) and the bottom set is about 6 to 8 inches lower. I am at work and do not have a parts manual or door here. I will check it out tomorrow and if I find anything different I'll correct with another post.
Clint
|
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |