Re: oops---------sore subject-


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by clueless [201.237.45.42] on Saturday, May 25, 2013 at 13:31:53 :

In Reply to: Re: oops posted by Kaegi [24.16.253.154] on Saturday, May 25, 2013 at 12:54:35 :

what did it come out of

again my front axle long shafts from the wc62 are one inch and 5 sixteenths in diameter, where as the outer shafts are the same diameter as the rear which is a full eigth of an inch less than the front long shafts

which tells me replacement rear shafts one and 5 sixteenths could be made splined on both ends and this would lean towards tuffer

all of the splines are the same dia., obviously, however the thin ones drop way down from the spline diameter vs the thicker
inner front shafts where there is almost no drop in thickness, maybe a u know what hair down in size

as i have said before i think the thicker shaft will help keep the splines from twisting in two vs the eight inch thinner shaft

curious -- mic yours and see what you get

i don t have a mike but used my eye and a tape measure---if it is not a full eigth in dia. it is the next best thing



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com