Re: spur gear question again


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Terry [184.146.216.8] on Saturday, April 20, 2013 at 07:37:12 :

In Reply to: spur gear question again posted by JD [12.184.11.194] on Friday, April 19, 2013 at 22:12:29 :

The bearings I installed have the sealed side to the ouside of the case. The inner bearing side is open to the gear lube in the tranny but the seal on the outer side helps prevent extra oil going towards the clutch along the input shaft. Make sure the front bearing retainer is clean inside especially where the coarse left hand threads are. These threads are designed to move oil back towards the bearing and into the case via the lower drain hole. Don't overfill the tranny as well. Terry



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com