Re: top steering knuckle bearing mount worn

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Vaughn on Friday, April 20, 2001 at 9:41AM :

In Reply to: Re: top steering knuckle bearing mount worn posted by Rob Steller on Friday, April 20, 2001 at 0:49AM :

Also VPW has a little book for a few bucks on repairing/replacing these trunion pins. The pins are identical to the original with a shoulder.

If your woodruff key has to be driven in the key way with a hammer, then it's good. If think your pin was about.004 off. Buy some .002 shim stock, cut it the same width as the cone and length allowing for the key, grease your trunion pin, and try driving the cone and shim stock on together. This will be the best fix outside of replacing the pin.

Follow Ups:

Re: top steering knuckle bearing mount worn - Rob Steller 11:52AM 04/20/2001

Re: top steering knuckle bearing mount worn - Vaughn 8:13PM 04/20/2001

Re: Thanks, I'll let you know how it works out. ntx - Rob Steller 8:34PM 04/20/2001

Post a Followup

Name:

E-Mail:

Subject:

Message:

Optional Link

URL:

Title:

Optional Image Link

URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com