Posted by Rob Steller on Thursday, April 19, 2001 at 9:33PM :
In Reply to: Re: top steering knuckle bearing mount worn posted by Randy Baker on Thursday, April 19, 2001 at 0:47AM :
Randy,
I see your point, though I have seen a couple of W-300's with loose bronze cones and the key just hogs out the slot in the bronze till it's usless. I'm still thinking on this one. Maybe a gadget that picks up the centers of top and bottom stubs, then pivots around and grinds, sort of like a tool-post grinder? Perhaps I can grind it down and press/heat shrink on a needle bearing inner race (a thin wall hard steel sleeve) Rob
This board is powered by the Mr. Fong Device from Cyberarmy.com |