|
|
Posted by Dana (in Lancaster) [50.138.254.55] on Sunday, December 16, 2012 at 08:41:23 :
In Reply to: Finished, sort of posted by Desoto61 [68.10.214.249] on Saturday, December 15, 2012 at 20:20:25 :
When fixed my seam I used a piece of solid stock and rounded it with t table sander to match the original curves of the seam metal. Then I welded studs on the back 10/32 I think about every 6 inches then bolted it into place. A little body seam filler to finish. Looked stock when I was done. Nowt that your seam is welded you could do the same.