Posted by Jonas on Tuesday, April 17, 2001 at 11:58AM :
In Reply to: Re: WDX BED QUESTION posted by Jonas on Tuesday, April 17, 2001 at 11:50AM :
What you are doing with the WDX bed is something I had attempted to do awhile back but ran out of time and extra money after the purchase of a plasma cutter. But I have about 20 of the short pockets cut out of 16 gauge steel and not bent up yet, and a set of wheel well dies made out of oak and edges wrapped with steel. Let me know if you could use any of them as I found a couple of beds that are straight. Also, are you going to marketing individual bed pieces as I just need a good front panel? Thanks.
|
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |