Posted by Kevin in Ohio on Friday, April 06, 2001 at 1:09PM :
In Reply to: Re: Another rivet question posted by Matt Wilson on Thursday, April 05, 2001 at 11:46PM :
On a side note. At work we grind steel for high speed punch presses. If something is taken undersize by a .0001 - .0002, on a part over an inch, we freeze it. When the piece is brought back down to room temp. it will normally grow that much on certain tool steels. The problem is EVERYTHING grows on the part so you have to skim all the other dimensions. Kevin
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |