|
|
Posted by Doc Dave [66.82.162.13] on Monday, May 28, 2012 at 19:16:47 :
In Reply to: beds strips/instalation posted by scott nepa [50.32.70.34] on Monday, May 28, 2012 at 18:13:19 :
I got my hardware- angle strips for the bed sides, and flat strips for between the boards, and finally bolts and washers from Mar-K. Very good quality.
I have heard Bruce Horkey is good too.
Have you taken the angle strips off the bed sides already? If not, scribe marks on the bed sides showing the position of the old angle strips to guide you when you put the new ones on. I cut through the spot welds on the old strips to remove them, then spot welded the new ones on after blasting, etc in the same location. I painted the angle strips with the bed sides since they were attached.