Re: Flat/Stake Bed Design question


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Will (in IL) [98.215.26.138] on Friday, April 20, 2012 at 15:11:14 :

In Reply to: Re: Flat/Stake Bed Design question posted by M Fanoni [65.98.184.194] on Friday, April 20, 2012 at 15:00:50 :

The c6x8.2 is probably stronger than the PW's frame, had hopped to some day add a hoist/dump to the bed, so I went heavy for the ones on the bed side.

I made a mistake/typo, the angles are 2" x 2" x 1/8", sorry about that, was thinking of another project.

I had not done any calculations on the cross members so good points, just went based on past use/experience. The widest span across on them is the 38" between the C's, guess I should consider that an area of concern.

Looks like I'll be around 400 pounds of steel in the bed with out the extra set of C-channel sections under it.

Thanks,
Will



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com