Re: WC & Power Wagon Door Patch Panels Manufacturer


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Keith Wolfe [98.236.84.49] on Thursday, January 19, 2012 at 22:39:19 :

In Reply to: WC & Power Wagon Door Patch Panels Manufacturer posted by Bob Stopka in PCB [108.109.112.64] on Thursday, January 19, 2012 at 20:44:52 :

I replaced both inner and outer panel on the same door on my power wagon. All I can say is I will never do that again. The inner panel out of the box looks great but it takes A LOT of fitting to get it to work and once you drill out the rivets on the lower hinge the door springs, you dont notice until to put the door back on the truck and it dosent fit. the outside panel I dont have anything good to say about it is flat and a power wagon door isnt flat I would have been ahead to make my own panel or cut pieces out of scrap doors. I made it work ant you cant tell but it was a real pain the panels were 100 dollars a peice so 200 in one door and at least a week of working on it to make them work. I just bought a set of doors off a fire truck that are as good as any I have ever seen on any truck and I paid a 100 a peice for them. My money goes with finding new doors from now on
just my 2 cents
Keith



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com