|
|
Posted by Vaughn [99.68.109.17] on Sunday, August 21, 2011 at 14:53:48 :
In Reply to: 12 volt coil wiring question posted by Robert Kosusnik [209.165.147.221] on Saturday, August 20, 2011 at 21:23:31 :
You need a four post solenoid to properly wire a 12v and use the ballest resistor.
From starter switch you need a wire to the "S" terminal on the solenoid
From the "I" terminal, you need a wire to the ballest side wire that goes to the coil. This is to by-pass the resistor to supply a full 12v to the coil when starting.
Everything is + to - on 12v. See PIF wiring diagrams