Posted by David on Monday, January 29, 2001 at 10:37PM :
In Reply to: solid engine mounts for 318? posted by Dave Pratt on Monday, January 29, 2001 at 9:03PM :
I don't think that I would use solid mounts at either end. These old trucks shake and vibration enough without any help..
One thing about the Helitool kit is the engineering you purchase that you don't have to do yourself. Call Helitool and see if you can get just the parts you need for the front. It would allow you to slip your engine/trans in one time. The front mounts will locate the engine at just the right spot in the engine bay. You should only have to manuever the back end around for the correct line up and then fab the rear mounts.
Are you using the 2WD version of this tranny or is married to the transfer case?
|
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |