Front and rear hubs are the same

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by RyanNJ [68.63.169.217] on Saturday, April 16, 2011 at 22:14:46 :

In Reply to: Re: Power Wagon Trailer/ WC 52 bed. Picture posted by Todd Somers [66.44.245.91] on Saturday, April 16, 2011 at 18:56:26 :

i have all four hubs off right now to pack wheel bearings. If you are not planing on using the drive axles and dont care about lubing the 3rd member with gear oil then the front drive flanges will work. you will need to remove the outer drive seal and replace the outer wheel bearing jam nut with one off of a front hub. you should prob remove the gear oil out of center section so it does not wash out your wheel bearing grease, or jam a plug in the axle tube and leave the oil. good luck. the trailer looks cool!

61ffpw

Follow Ups:

Re: Front and rear hubs are the same - Kaegi 23:02:19 04/16/2011

Re: Front and rear hubs are the same - RyanNJ 23:31:52 04/16/2011
- Re: Front and rear hubs are the same - Kaegi 02:06:58 04/17/2011
  - Re: Front and rear hubs are the same - RyanNJ 12:33:45 04/17/2011

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com