Made from 3/4" diameter rod, two lengths


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by ChrisCase [63.199.247.20] on Monday, March 07, 2011 at 17:00:40 :

In Reply to: Hand Crank posted by Bob Ibbotson [174.51.73.102] on Monday, March 07, 2011 at 15:02:05 :

Shorter for non-winch, about 16" long, long section. Longer for winch models, about 25"+.

So far as I know they came with every truck, under the seat, with the other tools.

I make my own, 3' of 3/4 rod. Heat with acetylene torch. I use a roll pin, inserted in a hole drilled in the same plane as the handle section, so it lays flat.

My first PW had a bad regulator, so I hand cranked it extensively between battery charges. DO NOT hook you thumb over the handle, keep it on the same side as your knuckles. Otherwise a kick-back can break your thumb. Hmmm, know what else? Maybe the timing is set at close to zero to saften up hand cranking? Fewer, milder kick backs that way?



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com