Re: Bearing clearance on 1T rear full floater


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Colby on Monday, January 08, 2001 at 9:33PM :

In Reply to: Bearing clearance on 1T rear full floater posted by gtk on Monday, January 08, 2001 at 2:09PM :

GT,
I looked in my shop manual and they recommend (assuming you've already got it apart) tightening the bearing adjusting nut so that the wheel cannot be shaken by hand but will roll without binding. Another trick is to tighten the bearing down snug and then back off 1/16 of a turn. The hard part is tightening the lock nut without turning the adjusting nut. They did not give any clearance specs in the book though.
Colby.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com