Posted by gtk on Tuesday, December 19, 2000 at 03:02:31:
In Reply to: Re: This might work ....? posted by Charlie on Tuesday, December 19, 2000 at 01:55:23:
It 's a 4 pinion. The pumpkin is out and I can verify the pinion count. It also uses the 7/16 studs for mounting. It's #6 on Table 5-1 in Zentmyer's Interchange manual. His numbers match to what I have in the factory parts book and photo so I think I have the correct ID of the diff. What else is required to mount the LockRight? Are thrust washers used to adjust the preload from the axle ends or does everything just ride on the pinion shafts? (As you can tell I have not installed a LockRight so please bear with the dumb questions) and thanks for the help.