Need m37 driveshaft to t/c and flanges still


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by 64w200crewcab [75.222.49.67] on Friday, July 23, 2010 at 09:24:56 :

In Reply to: Re: M-37 transfercase input yoke source? posted by Keith in Washington [24.41.41.111] on Thursday, July 22, 2010 at 15:53:51 :

Thanks Keith, where in the world can one purchase these parts at?? I am in Tecksus and went by PowerWagon Larry Cooks in Corpus Christi and he was out of parts, I called Sid Beck of Ace Surplus and he has sold out to Mullins Jeep and has nothing for sale either. Is there any online spicer crossover reference online?? Thanks for your coment, wish you could post up a picture of your set up driveshaft, Right now i am going to order a m37 driveshaft to t/c and then remove part of it and install the m35 spicer end to the front, all i need right now is a spicer type flange to convert my np201 to np200 spicer flange set up. Found some online but all out of state so far. Good news is I scored a SAE type 2 bellhousing for my 3.9 from Larry Cook yesterday so am gearing up for the conversion to 14 inch clutch out of FL70 Freightliner and master clutch clinder from same that has a factory bleeder valve. thanks all



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com