Cams

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Bob In Indy [70.88.69.206] on Tuesday, July 20, 2010 at 14:19:23 :

I have a 50 b2 ffpw with an industrial motor in it. Do you think they put the same camshafts in industrial motors as truck motors. If this motor was built to run a welder or a pump it would be build to run wide open or close to it.It doesnt have vacuum advance on the distributor. Is this train of thought rite or not. If I have to change a cam I would rather do it now when there is no sheet metal on my truck. Thanks for your imput.
Bob Ragan

Follow Ups:

Re: Cams - David 21:08:17 07/20/2010

Re: Cams - Kaegi 14:33:35 07/20/2010

Re: Cams - clueless 19:30:39 07/20/2010
- Re: Cams - Daryl in Oz 05:28:51 07/21/2010
  - Re: Cams - clueless 11:14:10 07/21/2010
    - cheaper - clueless 11:25:24 07/21/2010
- Re: Cams - Kaegi 21:46:36 07/20/2010
Re: Cams - David Sherman 15:06:34 07/20/2010
- Re: Cams - Kaegi 16:12:15 07/20/2010
  - gas - Dave 09:07:52 07/21/2010

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com