|
|
Posted by mannyc [68.165.89.2] on Thursday, May 27, 2010 at 17:00:01 :
In Reply to: Re: Going to stick with original design... posted by rick pacholski [98.26.211.168] on Thursday, May 27, 2010 at 16:12:42 :
i used a socket as mentioned to install the top and bottom bearings and used a split bearing tool to remove the old ones. i used an aluminum 'drift' to install the inner axle tube bushing. my drift is actually a tractor trailer axle seal installer that was turned down to center itself on the inner bushing and apply equal pressure during install.