Posted by Chriscase [76.212.163.231] on Thursday, March 11, 2010 at 21:11:00 :
In Reply to: Re: Backup switch posted by Keith in Washington [76.104.177.226] on Thursday, March 11, 2010 at 20:43:42 :
Drill and tap a hole into the reverse rail 'tunnel' in the tranny cover. Do it right in the truck, use a magnet to pick up the chips? Maybe pull an end cap ? Since the rail moves what 1 1/2"? switch location would not be too critical. Clearance to floor board would be the limit. I think. Tunnel wall would be thick enough to hold the switch. I think. If too thin, braze up a lump, right in the truck.
There I go, thinking again...