|
|
Posted by Rorry [76.251.185.112] on Friday, February 26, 2010 at 17:51:15 :
In Reply to: Re: Full time 4X4 to part time 4xX4 Conversion posted by Kevin Clause [99.18.28.34] on Friday, February 26, 2010 at 11:00:48 :
Bad advice..You could end up with the wheel brgs going south just like my brother in laws truck did him.Then you got to look for the complete outer ends.Best thing to do is jack each side up and feel the play in the wheel bearings.When I said outer ends I meant the wheel bearings.If its tight and you buy the truck,be sure and remove the front wheels and use the hole thats drilled in the rotor,rotate it,and find the grease zerk and grease the heck out of it.Do that aroung every oil change and it should work for a long time.Dont run it without the front shaft..Hard on the T-case and front axle.Will cost you in the long run..Past experiances LOL.