Re: Turning shaft on lathe

Posted by Jerry in Idaho [64.139.238.43] on Tuesday, December 01, 2009 at 19:05:03 :

In Reply to: Re: Turning shaft on lathe posted by David Sherman [216.18.131.193] on Tuesday, December 01, 2009 at 18:16:39 :

If I could go back 30 or 40 years, I would do a lot of things, like maintenance on my own body! Are you sure you want to use a steel gear on the steel worm? I guess if it's only used occasionally it might be all right.
Did you verify that it is an MU2?

• Tom's Differentials

Follow Ups:

• Steel gear - David Sherman 20:16:44 12/01/2009
  • Re: Steel gear - Jerry in Idaho 20:48:17 12/01/2009
    • Re: Steel gear - David Sherman 22:52:01 12/01/2009
    • Re: Steel gear - bill in pa 21:10:26 12/01/2009
      • Re: Steel gear - Jerry in Idaho 00:41:25 12/02/2009

Post a Followup