I did build a couple jigs....


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Chriscase [76.201.17.225] on Thursday, November 19, 2009 at 23:46:10 :

In Reply to: pipes posted by Dave Royal [76.182.149.93] on Thursday, November 19, 2009 at 20:02:26 :

I can reproduce the set on my truck. Exhaust and intake, carb flange to suit your needs. 16ga steel mandrel bends. $750 plus shipping.

The universal bends only have four more welds than custom bends would.

I figured the better exhaust flow took precedence over using the stock intake. A bigger carb is needed. I think a single carb has to flow better than duals, since duals would require a primitive 'log' manifold that I think starves the middle cylinders. My design ought to work better. I think...

It hasn't had an 'after' dyno test. But it does run lots better, keeps up with the 18 wheelers on the freeway, even on hills. Well, not the empty ones. ;)



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com