|
|
Posted by Paul (in NY) on Thursday, June 11, 2009 at 16:10:29 :
In Reply to: gooseneck hitch posted by scott c ohio on Thursday, June 11, 2009 at 12:45:53 :
In the picture, the steel marked with Red Dots is the added steel for the Gooseneck Mount. I used a Draw-Tite removable ball mount. The Bumblebee's bed is 3/16" diamond plate. I cut the opening in the diamond plate to match the Draw-Tite mount, then trimmed it with 1.0" x 1.0" x 3/16" angle. Finally everything was shot with Line-X.
You can also go to my Image Event Receiver Hitch album. In that album, you will see some pictures with the Gooseneck Hitch...not yet finished with Fabrication.
http://imageevent.com/moosecreekmaple/pwreceiverhitch
Paul