Re: pwrwag trans


[ Follow Ups ] [ Post Followup ] [ Dodge Power Wagon Forum ] [ FAQ ]

Posted by John Mallet on January 16, 1998 at 20:36:18:

In Reply to: pwrwag trans posted by ec on January 15, 1998 at 10:48:35:

I used to have an NP420 but upgraded to an NP435 which is a bolt on deal. The bolt pattern for the bell housing is approximately 8.5" from center to center of the two top bolt holes, 2.5" center to center between the two holes on the driver side of the housing, and 2.75" center to center between the two holes on the passenger side of the housing. The input shaft is 1 inch 10 tooth spline.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Dodge Power Wagon Forum ] [ FAQ ]