Posted by vince on September 05, 2000 at 00:36:32:
In Reply to: oil pressure gage& external oil filter ect.... posted by Max on September 04, 2000 at 23:01:51:
Well, I dunno all the answers here. I do know that the oil filter and gauge both plumb into holes in the side of the block, right near the dipstick. I understand that they both lead to the same passage in the engine.
12 volt conversion.....make an alternator fit, then wire it up, or try to find a street rod kit, or there may be some kits available from some of the advertisers. I used a Bosch alternator from a BMW 320i, internal regulator, just needed to modify the pulley remove about 1/4 inch of material from one boss and it fits fine.
Hope this helps a little,
vince