|
|
Posted by Caleb (Kansas City) on Sunday, January 11, 2009 at 15:51:28 :
I got me rear end all taken apart. So far everything looks really good. The bearings all look almost new and the ring may have been replaced at some point.
The breaks are in decent shape too, the linings have about 1/4 inch thickness but the drums are a little grooved. I may see if I can get them turned. My question is on the wheel cylinders. There are two different bores on each cylinder. 1 3/8" on one end and 1 1/4" on the other. Do I order the 1 3/8 kit and it will have the smaller cup, or do I have a strange case and need to order 2 of each kit?
Follow Ups: