|
|
Posted by Nort on Wednesday, October 15, 2008 at 15:33:25 :
In Reply to: Can't get truck to start :( posted by Galen on Wednesday, October 15, 2008 at 09:02:23 :
I would do one thing at a time starting with fuel. Take the off the fuel pump that goes to the the tank and hook a short hose in it's place that can reach a gas can on the floor. Put the hose in the can and turn the engine over to see if you are getting fuel. If you don't have fuel then cahnces are you got a bad fuel pump.
Start with checking to see if you have juice to the coil and then to the dist. If you are going to change the points and cond. then I suggest pulling the dist., it's much easier and you'll do a better job of getting them set. Make sure to mark where the dist. is in the engine and which direction the rotor is pointing (180deg. off). Nort