|
|
Posted by bill in pa on Monday, June 23, 2008 at 19:47:38 :
In Reply to: Re:bell housing.... posted by Kevin in Rehoboth on Monday, June 23, 2008 at 11:13:01 :
my bell housing is much rounder on the top. Does not have the flat section in the back to fit to the tranny overhang. Mine did not clear where the case top over hangs the front. Does your tranny also have a bearing cap with four bolts on the front,just below the input shaft? What is your bell from? year,make,model. Mine is from a 78 360 non hydraulic clutch.
Follow Ups: