|
|
Posted by John Waak on Sunday, May 25, 2008 at 18:03:22 :
In Reply to: greasing by braile posted by copey on Sunday, May 25, 2008 at 13:13:14 :
Copey,
IF you are referring to greasing the steering knuckle on a FFPW or M37,the zerk is located on the top of the knuckle housing. There is a flat plate on top. The zerk is in the middle of that plate. Before adding grease, however, find and remove the 1/8 npt plug that is located on the lower half of the round part of the housing. Once that plug is removed, add a high quality #2 grease through the top zerk. Keep it coming until you see excess grease beginning to be pushed out of the 1/8 inch hole from which you removed the plug. Wait a bit until no more grease is oozing out. Put the plug back in and you should be ready to go.
IF you are not referring to the steering knuckle. . . never mind.
Follow Ups: