Re: Master Metal Fab Question--OT

Posted by MoparMogSteve on Wednesday, May 21, 2008 at 14:40:16 :

In Reply to: Re: Master Metal Fab Question--OT posted by MoparMogSteve on Wednesday, May 21, 2008 at 10:19:22 :

Go to Acrobend.com and click on the hand rotary benders. There is a small one at the bottom of the page that maybe usefull. No prices given though.

Re: Master Metal Fab Question--OT - MoparMogSteve 15:25:45 05/21/2008

cheap jig - SUPRDUD 18:47:17 05/21/2008
- Re: To inpress the gals - George (AB) 02:08:42 05/22/2008
- Re: cheap jig - MoparMogSteve 20:45:01 05/21/2008
  - Re: cheap jig - SUPRDUD 19:44:36 05/22/2008
Cool tool! wish I needed one. nm - Chris Case @ San Diego 15:40:40 05/21/2008

This board is powered by the Mr. Fong Device from Cyberarmy.com